Baicells Nova 442i
The Baicells Nova 442i is part of the outdoor series of Baicells. The Nova 442i is an advanced two-carrier outdoor eNodeB (eNB) compliant with 3GPP LTE TDD technology. This 4x4W eNB operates in Carrier Aggregation (CA) mode or Dual Carrier (DC) mode
Quick Navigation
Prerequisites
Nova 442i
Monogoto Edge
Configuration data to connect the eNodeB to Monogoto Edge Reach out to support@monogoto.io if you haven't received the config data yet
Getting Started
The Baicells Nova 442i can be integrated with Monogoto Edge support Local Break Out (LBO)
Connect the Monogoto Edge to your internet router using an ethernet cable connected to Port 1.
Connect the power cable of the Monogoto Edge.
Connect an ethernet cable from the Monogoto Edge Port 2, to the POE port of the Nova 442i.
Connect the GPS antenna, to the GPS port of the Nova 442i.
Connect your computer to the Switch to configure the eNodeB.
Connect the power cable to the Nova 442i.
Connect your computing to the Baicells Nova 442i
Open the web browser and enter the IP address of the eNodeB, which is most likely:
192.168.150.1
Login using the username and password:
admin
/admin
Make sure to update your password after the first login.
Baicells Nova 442i Configuration Guide For detailed documentation about the Nova 442i, review the Baicells Configuration Guide
Baicells Nova 442i Configuration
Set Quick Setting
In the Nova 442i configuration portal, select Basic Setting->Quick Setting in the navigation bar.
FrequencyBand: Specify the LTE band you would like to use
EARFCN: Use the address received from Monogoto
CellIDnity: Use the address received from Monogoto
Set MME IP Address to:
Monogoto Edge MME ip
Set TAC according to the details received by Monogoto.
Under PLMNID set it to:
315010
Select Save to save the configuration settings
Set Core Network
In the Nova 442i configuration portal, select Basic Setting->Core Network in the navigation bar.
Set MME IP Address to:
Monogoto Edge MME ip
Under PLMNID set it to:
315010
Select Save to save the configuration settings
Validate the connection
Select Basic setting->Basic Info.
To validate the successful connection, review the Cell State and MME Status:
The Cell State should report:
Active
The MME Status should report:
Connected
Do you see a successful connection? Congratulations! Your eNodeB is successfully set up 🎉
Useful Links
Last updated