T&W N02008
Last updated
Last updated
The T&W N02008 is part of the indoor Pico Cell N020XX series of T&W. The eNodeB comes in different versions, supporting different LTE bands.
T&W N02008
Mikrotik RB4011 router
Configuration data to connect the eNodeB to Monogoto cloud Reach out to support@monogoto.io if you haven't received the config data yet
The T&W N02008 does NOT support Local Break Out (LBO), meaning that all data is going to Monogoto’s cloud before being forwarded to the customer's endpoint.
Connect the Mikrotik RB4011 to your internet router using using an ethernet cable connected to Port 1.
Connect the power cable of the Mikrotik.
Connect an ethernet cable from the Mikrotik RB4011 router Port 2, to the WAN port of the N02008.
Connect your computer to the LAN port of the N02008 to configure the eNodeB.
Connect the power cable to the N02008.
The POWER LED will turn green.
Open the web browser and enter the IP address of the eNodeB, which is most-likely: 192.168.0.101
Login using the username and password: admin / Pico@2018
Make sure to update your password after the first login.
T&W User Manual For detailed documentation about the T&W N02008, review the T&W User Manual
In the N02008 configuration portal, select Management -> Cell in the navigation bar.
Set S1SigLinkServer to: 10.201.121.242
Set Duplex Mode to: TDD
Set TAC according to the details received by Monogoto.
Under PLMNID, enable the PLMNID1 and set it to: 315010
Select Submit to save the configuration settings
Click on Cell1 and fill out the details below:
EARFCNDL: Use address received from Monogoto
EARFCNDLInUse: Use address received from Monogoto
FreqBandIndicator: Specify the LTE band you would like to use
Click on Cell2 and fill out the details below:
EARFCNDL: Use address received from Monogoto
EARFCNDLInUse: Use address received from Monogoto
FreqBandIndicator: Specify the LTE band you would like to use
Go to Management -> Network in the navigation bar.
Select IP
Create 2 static IP Interfaces, according to the configuration received from Monogoto (starting with 10.5X)
Make sure to enable VLAN for both IP addresses
Go to Management -> Network in the navigation bar.
Select Route
Create a new static route:
Dest IP Address: 10.201.121.242
Dest Subnet Mask: 255.255.255.255
Gateway IP Address: Use address received from Monogoto
Reboot the T&W N02008 for the changes to take effect.
Go to Management → Factory → Reboot
Press Reboot
Select Management -> Cell.
To validate the successful connection, review AssocStatus and S1Status:
The AssocStatus should report: Active
The S1Status should report: Success
Do you see a successful connection? Congratulations! Your eNodeB is successfully set up 🎉
