Baicells Stellar 227

The Baicells Stellar 227 is part of the indoor series of Baicells. The gNodeB comes in different versions, supporting different 5G bands.

Quick Navigation

Prerequisites

  • Stellar 227

  • Monogoto Edge

  • Configuration data to connect the gNodeB to Monogoto Edge Reach out to support@monogoto.io if you haven't received the config data yet

Getting Started

The Baicells Stellar 227 can be integrated with Monogoto Edge support Local Break Out (LBO)

Connect the Monogoto Edge to your internet router using an ethernet cable connected to Port 1.

Connect the power cable of the Monogoto Edge.

Connect an ethernet cable from the Monogoto Edge Port 2, to the WAN port of the Stellar 227

Connect the GPS antenna, to the GPS port of the Stellar 227.

Connect your computer to the LAN to configure the gNodeB.

Connect the power cable to the Stellar 227.

The POWER LED will turn green.

Connect your computing to the Baicells Stellar 227

  • Open the web browser and enter the IP address of the gNodeB, which is most likely: 192.168.150.7

  • Login using the username and password: new_user / gNB@a*b*c*d*

Each gNodeB has an exclusive default password, which is formatted as gNB@a*b*c*d*, where * represents the last four digits of the gNodeB Serial Number (SN). For example, if the last four digits of the gNodeB SN are 1234, then the default password for that gNodeB would be gNB@a1b2c3d4.

Baicells Stellar 227 Configuration Guide For detailed documentation about the Stellar 227, review the Baicells Configuration Guide

Baicells Stellar 227 Configuration

Set Basic Parameters

In the Stellar 227 configuration portal, select NR Setting->Advanced->PLMN in the navigation bar.

  • Set CEELID / TAC to: 1

  • Set PLMNID to: 315010

  • Set SST set it to: 1

  • Under SD Value set it to: 66051

select NR Setting->Advanced->CU in the navigation bar.

  • Set AMF IP Address to: Monogoto Edge AMF ip

  • Set NGAP IP Address to: gNodeB WAN ip

  • Under PLMNID set it to: 315010

Select Save to save the configuration settings

Security Ciphering Algorithm

select NR Setting->Security Algorithm.

Set Cipher NEA 1 Algorithm to: ON

Validate the connection

Select Basic setting->Basic Info.

To validate the successful connection, review the Cell State and NG /F1 Status:

  • The Cell State should report: Active

  • The NG /F1 Status should report: Active

Do you see a successful connection? Congratulations! Your gNodeB is successfully set up 🎉

Last updated