Baicells Neutrino 430
Last updated
Was this helpful?
Last updated
Was this helpful?
The Baicells Neutrino 430 is part of the indoor series of Baicells. The eNodeB comes in different versions, supporting different LTE bands.
Neutrino 430
Monogoto Edge
Configuration data to connect the eNodeB to Monogoto Edge Reach out to support@monogoto.io if you haven't received the config data yet
The Baicells Neutrino 430 can be integrated with Monogoto Edge support Local Break Out (LBO)
Connect the Monogoto Edge to your internet router using an ethernet cable connected to Port 1.
Connect the power cable of the Monogoto Edge.
Connect an ethernet cable from the Monogoto Edge Port 2, to the WAN port of the Neutrino 430.
Connect the GPS antenna, to the GPS port of the Neutrino 430.
Connect your computer to the Switch to configure the eNodeB.
Connect the power cable to the Neutrino 430.
The POWER LED will turn green.
Open the web browser and enter the IP address of the eNodeB, which is most likely: 192.168.150.1
Login using the username and password: admin / admin
Make sure to update your password after the first login.
Baicells Neutrino 430 Configuration Guide For detailed documentation about the Neutrino 430, review the Baicells Configuration Guide
In the Neutrino 430 configuration portal, select Network->Core Network in the navigation bar.
Set MME IP Address to: Monogoto Edge MME ip
Set TAC according to the details received by Monogoto.
Under PLMNID set it to: 315010
Select Save to save the configuration settings
Select Basic setting->Basic Info.
To validate the successful connection, review the Cell State and MME Status:
The Cell State should report: Active
The MME Status should report: Connected
Do you see a successful connection? Congratulations! Your eNodeB is successfully set up 🎉
