The Mosolabs SCO4255P is part of the indoor/outdoor series of Mosolabs. The eNodeB comes in different versions, supporting different LTE bands.
Mosolabs SCO4255P
Monogoto Edge
Configuration data to connect the eNodeB to Monogoto Edge Reach out to [email protected] if you haven't received the config data yet
The Mosolabs SCO4255P can be integrated with Monogoto Edge support Local Break Out (LBO)
Connect the Monogoto Edge to your internet router using an ethernet cable connected to Port 1.
Connect an ethernet cable from the Monogoto Edge Port 2 to PoE++ (WAN) port of the SCO4225P.
Connect the power cable of the Monogoto Edge.
Connect your computer to the LAN port of the SCO4225P to configure the eNodeB.
Connect the power cable to the SCO4225P.
The POWER LED will turn green.
Open the web browser and enter the IP address of the eNodeB, which is most likely: 11.11.11.188
Mosolabs SCO4255P Configuration Guide For detailed documentation about the SCO4255P, review the Mosolabs Configuration Guide
In the SCO4255P configuration portal, select Manage-> LTE Basic Setting in the navigation bar.
FrequencyBand: Specify the LTE band you would like to use
EARFCN: Use the address received from Monogoto
CellIDnity: Use the address received from Monogoto
Set MME IP Address to: Monogoto Edge MME ip
Set TAC according to the details received by Monogoto.
Under PLMNID set it to: 315010
Select Save to save the configuration settings
Select State->LTE Status.
To validate the successful connection, review the S1 State and Cell State:
The S1 State should report: Connected
The Cell State should report: Stack Running
Do you see a successful connection? Congratulations! Your eNodeB is successfully set up 🎉
Last updated
Was this helpful?
Was this helpful?
