Foxconn T99B226
Last updated
Last updated
The Foxconn T99B226 is an a compact, high output power, resilient CBRS (Citizens Broadband Radio Service) LTE compliant Small Cell. This device is water and dust resistant (IP65) and can be pole mounted, making it suitable to be deployed both indoors and outdoors.
The LTE CA technology deployed in this outdoor small cell is compliant with the specifications defined by IEEE 3GPP alliance. This small cell has four LTE antenna ports and one GPS antenna port and is powered by a 56V DC PoE. Its LTE interface operates in CBRS band and supports SAS (Spectrum Access System). By using GPS timing synchronization, handover between various small cells can be achieved. This is essential for scenarios that require quick switches between base stations, such as AGV (Automatic Guide Vehicle) that is used in factory automation.
Foxconn T99B226
Mikrotik RB4011 router
Configuration data to connect the eNodeB to Monogoto cloud Reach out to support@monogoto.io if you haven't received the config data yet
The T99B226 does NOT support Local Break Out (LBO), thus all data is going to Monogoto’s cloud before being forwarded to the customer's endpoint.
Connect an ethernet cable from port 1 of the Mikrotik RB4011 router to an ethernet port and connect the power cable.
Connect an ethernet cable from the eNodeB to the Mikrotik RB4011 router and connect it to power.
When the eNodeB powers on, LED3 will turn green. When the ethernet link is up, LED2 will turn green.
Foxconn Manuals For detailed instructions about the Foxconn T99B226, review the below manual:
The factory default login address of the Small Cell management page is 192.168.152.1. Set the computer’s subnet as 192.168.152.0/24 to access the webpage.
Use the login using credentials received from the manufacturer.
Visit Basics Setting
WAN Configuration
Set the WAN Configuration to Manual.
Fill out the IP Address, Subnet Mask and Gateway according to the information received from Monogoto.
shareRAN Configuration
Set EPC Address to 10.201.121.242
Set PLMNList to 315010
Set TAC to 512
Configure the SAS Server
When using band 48 in the US: configure your SAS Server to any approved SAS provider.
Visit Advanced Setting
Fill out the following details for CELL 1
FreqBandIndicator: set to 42, 43 or 48 (CBRS)
EARFCN UL: Use address received from Monogoto
EARFCN DL: Use address received from Monogoto
Fill out the following details for CELL 2
FreqBandIndicator: set to 42, 43 or 48 (CBRS)
EARFCN UL: Use address received from Monogoto
EARFCN DL: Use address received from Monogoto
Look at the LEDs at the bottom of the eNB. Do you see LED1, LED2 and LED3 turned green and none of the LEDs are red? Congratulations! Your eNodeB is successfully set up 🎉
